Dell PowerEdge M420 User Manual - Page 4

Browse online or download pdf User Manual for Switch Dell PowerEdge M420. Dell PowerEdge M420 26 pages. Dell poweredge blade servers getting started guide
Also for Dell PowerEdge M420: Information Update (38 pages), Release Notes (27 pages), Manual (25 pages), User Manual (23 pages), Important Information Manual (35 pages), Update Manual (32 pages), Update Manual (28 pages), User Manual (22 pages), Getting Started Manual (12 pages), Manual (38 pages), Technical Manual (46 pages), Technical Manual (48 pages), Portfolio Manual (27 pages), Getting Started Manual (14 pages), Getting Started Manual (12 pages)

Print Page

Rev 1.00

About this Manual

This manual describes the installation and basic use of the Dell 10Gb Ethernet Pass Through II for

M1000e.

This manual is intended for users and system administrators responsible for installing and setting

up the I/O module.

Table 2 - Abbreviations and Convention

Term

IOM

PTM

Downlink

Uplink

SSH

CMC

Component

Component numbering

http://support.dell.com/support/

Definition

I/O Module

Pass Through Module

Internal link – from servers to 10GbE PTM PHY (through the mid plane connector)

External link – from 10GbE PTM PHY to external link (typically connected to Ethernet switch)

Secure Shell (also refers to a software program that allows connectivity using an SSH protocol.)

Chassis Management Controller

10GbE PTM PHY device

Components are numbered from one (1) to three (3).

When looking at the 10GbE PTM component side with external connectors (uplink) up, the compo-

nents are numbered as follows:

Device number 1 is the right-most component

Device number 2 is the middle component

Device number 3 is the left-most component

Wherever applicable, device number 0 refers to the on-board micro-controller

Software User's Manual