Christie 104-001001 Replacement Instructions Manual - Page 4
Browse online or download pdf Replacement Instructions Manual for Projector Christie 104-001001. Christie 104-001001 8 pages.
Print Page
+
S
12K / 14K / 16K / 20K Lamp & Filter Instructions
STEP 7 - RE-INSTALL LAMP RETAINING BAR
(a)
Position the retaining bar along the bottom edge of the lamp module, with the ends
positioned under the alignment guides. If the bar does not fit, push the lamp
module in further.
(b)
Secure screw
B
(c)
Secure screw
A
(d)
Go back and forth between
correctly position the lamp module. Refer to Figure 5.
STEP 8 — CLOSE LAMP DOOR
Close the lamp door and lock the ¼-turn lock screws (2).
Do not attempt to re-align or adjust the lamp module.
STEP 9 - INSTALL THE AIR FILTER
While the projector is still off, replace the air filter. For more information, refer to the Filter
Replacement Procedure, on page 6.
013-100049-03 (Rev.1)
IMPORTANT
The tightening order of the screws is
critical for proper lamp contact and alignment.
until just engaged.
until just engaged.
and
to lock the bar in place with even pressure and
A
B
Figure 5. Install Retaining Bar
IMPORTANT
The lamp module is calibrated for maximum
performance and brightness in this projector.
4 of 8 Pages