Dell PowerEdge M820 Systems User Manual - Page 13

Browse online or download pdf User Manual for Switch Dell PowerEdge M820 Systems. Dell PowerEdge M820 Systems 26 pages. Dell poweredge blade servers getting started guide
Also for Dell PowerEdge M820 Systems: Information Update (38 pages), Release Notes (27 pages), User Manual (23 pages), Important Information Manual (35 pages), Update Manual (32 pages), Update Manual (28 pages), User Manual (22 pages), Getting Started Manual (12 pages), Owner's Manual (3 pages), Technical Manual (46 pages), Portfolio Manual (27 pages), Getting Started Manual (14 pages), Getting Started Manual (12 pages), Technical Manual (47 pages)

Print Page
Dell PowerEdge M820 Systems User Manual
Dell 10Gb Ethernet Pass Through II
Command name
show port module
Debug Commands
cr_read
cr_write
3.3

CLI Command Reference Conventions

This section describes the 10GbE PTM CLI commands.
For each command, the following information is provided:
• Synopsis:
Lists the command name and any required or optional parameters. Variable parameters (like port
numbers) are shown in italics. Optional parameters are shown in square brackets, e.g.
[optional_parameter]. Required parameters are shown with no brackets.
• Description:
Provides a detailed description of the command and of all its parameters
• Example:
Usage example and command output.
For purpose of automation, the symbol '#' is used to indicate a comment that extends until the
next new-line character.
3.4

General Commands

3.4.1
help
Synopsis:
help
Description:
Show the list of all available commands.
ADMIN: when in ADMIN mode, this command will also show commands that require
ADMIN privilege level.
Example:
# help
Table 5 - List of Commands
Short Description
Shows uplink module parameters
To read a 32 bit register from device number
device_num.
To write a data DWORD to address
0xHex_address to device number
device_num.
Reference
Section 3.7.2, "show port module," on
page 17
Section 3.8.1, "cr_read (ADMIN)," on
page 17
Section 3.8.2, "cr_write (ADMIN)," on
page 18
Rev 1.00
13