Dell R1-2401 Getting Started Manual - Page 15
Browse online or download pdf Getting Started Manual for Switch Dell R1-2401. Dell R1-2401 30 pages. Poweredge vrtx switch modules
Also for Dell R1-2401: Getting Started Manual (20 pages)
- 1. Getting Started Guide
- 1. 1 Hardware and Initial Configuration
- 1. Switch Hardware
- 1. Initial Configuration of the Switch
- 2. Table of Contents
- 2. 2 Using the CLI
- 2. CLI Command Conventions
- 2. Accessing the Device through the CLI
- 2. Retrieving an IP Address
- 2. Security Management and Password Configuration
- 2. Configuring Login Banners
- 2. Startup Menu Procedures
- 2. Software Download
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Button
all
Accessing the Device Through the CLI
You can manage the device using CLI commands, through the CMC to the
terminal console, or via a Telnet connection.
Through CMC
Insert the device into the chassis and enter the CLI commands upon
receiving a prompt.
Telnet Connection
Telnet is a terminal emulation TCP/IP protocol. RS-232 terminals can be
virtually connected to the local device through a TCP/IP protocol network.
Telnet is an alternative to a local login terminal, where a remote login is
required.
The device supports up to four simultaneous Telnet sessions. All CLI
commands can be used over a Telnet session.
If access is via a Telnet connection, ensure that the device has an IP address
and that software has been downloaded to the device.
To start a Telnet session:
1 Select Start > Run.
The Run window opens.
2 Type cmd.
The cmd window opens.
3 In the cmd window, type Telnet <IP address> <Enter>.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 3 / 6 / 1 3 - F O R P R O O F O N LY
Plasma\GSG\Plasma_UGUsing_CLI.fm
Description
When a parameter is required to define a range of ports or
parameters and all is an option, the default for the command
is all when no parameters are defined. For example, the
command interface range port-channel has the option of
either entering a range of channels, or selecting all. When the
command is entered without a parameter, it automatically
defaults to all.
Using the CLI
15