Dell S4048-ON Configuration Manual - Page 12
Browse online or download pdf Configuration Manual for Switch Dell S4048-ON. Dell S4048-ON 30 pages. Enterprise switches
Also for Dell S4048-ON: Configuration Manual (19 pages), Troubleshooting Manual (29 pages)
Print Page
Switch configuration (OS 9.x)
2.2
Configure Data Center Bridging (DCB) (optional)
Use the following commands to enable DCB mode on the switch.
Note: You must complete the Dell EMC recommended switch configuration steps in section 2.1 before
configuring the switch for DCB mode.
2.2.1
Disable 802.3x flowcontrol on SFP+ ports
Dell#configure
Dell(conf)#interface range tengigabitethernet 1/1–1/48
Dell(conf-if-range-te-1/1-48)#no flowcontrol rx on tx off
Dell(conf-if-range-te-1/1-48)#exit
2.2.2
Disable 802.3x flowcontrol on QSFP ports
Dell(conf)#interface range fortyGigE 1/49 , fortyGigE 1/50
Dell(conf-if-range-fo-1/49-50)#no flowcontrol rx on tx off
Dell(conf-if-range-fo-1/49-50)#exit
2.2.3
Enable DCB and reload
Dell(conf)#dcb enable
Dell(conf)#exit
Dell#copy running-config startup-config
Dell#reload
Note: After confirming reload request, the switch will reboot.
2.2.4
Create tagged VLAN for all ports and port-channels
Dell#configure
Dell(conf)#interface vlan <vlan-id>
Note: You must supply a VLAN id. The valid range is 2-4093.
Dell (conf-if-vl-vlan-id*)#no shutdown
Dell (conf-if-vl-vlan-id*)#tagged tengigabitethernet 1/1–1/48
Dell (conf-if-vl-vlan-id*)#tagged port-channel 1
Dell (conf-if-vl-vlan-id*)#exit
12
Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026