Dell S4148-ON Configuration Manual - Page 9

Browse online or download pdf Configuration Manual for Switch Dell S4148-ON. Dell S4148-ON 19 pages. Dell emc sc series sans

Print Page

Dell EMC recommended switch configuration

2.6

Configure login credentials

OS10(config)# username admin password $0$<password>

2.7

QSFP+ and QSFP28 ports on S4148-ON and S4128-ON switches can be configured as breakouts to be used

with 10GbE iSCSI storage or server network adapters. To configure these ports as 4 x 10GbE ports, use the

following commands.

OS10(config)# interface breakout 1/1/<port-number> map 10g-4x

OS10(config)# exit

OS10#

Use the following command to check the port interface status:

OS10# show interface status

2.8

Switch ports are enabled and are configured for switchport mode access by default for S4148-ON and

S4128-ON switches. If choosing to reconfigure the ports, use the following steps.

Option 1: Enable ports individually by entering the port number.

OS10# configure terminal

OS10(config)#interface ethernet 1/1/1

Note: For ports configured as 4 x 10GbE breakout ports, use the following command in which 1/1 represents

the switch number, xx represents port number, and yy represents sub port number:

OS10(conf)#interface ethernet 1/1/xx:yy

OS10(conf-if-eth1/1/1)# switchport mode access

OS10(conf-if-eth1/1/1)# no shutdown

OS10(conf-if-eth1/1/1)# exit

Option 2: Enable multiple ports at once using the range parameter.

OS10# configure terminal

OS10(config)# interface range ethernet 1/1/1–1/1/54

Note: For ports configured as 4 x 10GbE breakout ports, use the following command in which 1/1 represents

the switch number, xx represents port number, and yy represents sub port number:

OS10(conf)#interface range ethernet 1/1/xx:yy-1/1/xx:yy

OS10(conf-range-eth1/1/1-1/1/54)# switchport mode access

OS10(conf-range-eth1/1/1-1/1/54)# no shutdown

OS10(conf-range-eth1/1/1-1/1/54)# exit

9 Dell EMC Networking S4148-ON and S4128-ON Switch Configuration Guide for Dell EMC SC Series SANs | SCG3704