Dell S6010-ON Installation Manual - Page 37
Browse online or download pdf Installation Manual for Switch Dell S6010-ON. Dell S6010-ON 46 pages.
Also for Dell S6010-ON: Firmware Release Notes (12 pages)
Print Page
Micro USB-B console port access
The Micro USB-B console port is to the left of the RS-232/RJ-45 console port on the I/O side of the switch.
NOTE:
The S6010-ON switch uses the Silicon Labs CP2109 USB-B chip. To find the correct USB-B universal asynchronous
receiver-transmitter (UART) driver, see
drivers.
The terminal settings are the same for the Micro USB-B console port and the RS-232/RJ-45 console port:
•
115200-baud rate
•
No parity
•
Eight data bits
•
One stop bit
•
No flow control
NOTE:
The Micro USB-B console port does not provide console access in the ONIE bootloader or ONIE. To navigate the ONIE
bootloader and access ONIE, use the RS-232/RJ-45 serial console port.
NOTE:
Before starting this procedure, be sure that you have a terminal emulation program already installed on your PC. Install
the appropriate drivers to support the Micro USB-B port. For assistance, contact Dell Technical Support.
1
Power on the PC.
2
Connect the USB-A end of cable into an available USB port on the PC.
3
Connect the Micro USB-B end of cable into the Micro USB-B console port on the system.
4
Power on the system.
5
Install the necessary USB device drivers.
You need an internet connection. For assistance, contact Dell Technical Support.
6
To access the S6010–ON, open your terminal software emulation program.
7
Keep the default terminal settings as follows:
•
115200-baud rate
•
No parity
•
Eight data bits
•
One stop bit
•
No flow control
USB storage mount
USB storage does not automatically mount. The supported file system is FAT. To use USB storage, you must first mount the device.
1
Create a mount directory for the USB.
ONIE:/ # mkdir /mnt/usb
2
View the fixed disks using fdisk.
ONIE:/mnt # fdisk -l
For internal storage:
Disk /dev/sda: 15.8 GB, 15829303296 bytes
255 heads, 63 sectors/track, 1924 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot
/dev/sda1
https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-
Start
End
1
1925
Blocks
Id System
15458303+ ee EFI GPT
Management ports
37