EarthQuake Cinenova Grande User Manual - Page 8
Browse online or download pdf User Manual for Amplifier EarthQuake Cinenova Grande. EarthQuake Cinenova Grande 16 pages. 5/7 channel power amplifier
Print Page
Pre-setup
Getting Started
Confirm the voltage setting of the amplifier. It must match the voltage in your
home. The amp is set by factory to either 120V or 240V. Check above the
circuit breaker for this information.
Amplification Block Plate
8
Power Plate
1) INPUT SELECTION
Set the input control to
either RCA or XLR. This
tells the amp which
input type will be used.
3) SPEAKER CONNECTIONS
A pair of binding posts is
p r o v i d e d f o r e a c h
channel. These posts
accept bare wire, spade
lugs & banana type
plugs. If bare wire is
u s e d t h e n , s t r i p
approximately 1/2 inch
to 3/4 inch of insulation
from the end of each
wire and carefully twist
the strands of each
conductor together.
Then insert.
5) PLUG IN POWER CORD
Plug the AC power cord
into the amp first then
into the wall outlet.
Make the connection in
place firmly.
Earthquake Sound
2) X-OVER MODE SELECTION
The Cinénova Grande
h o u s e s
5
o r
7
amplification blocks.
Each block comes
equipped with a 3-way
Mode Selection switch.
Generally the amplifier
Is used in By Pass
mode and fed a crossed
signal from a processor.
U n l e s s o t h e r w i s e
See Page-12
desired, the crossover
For Filter
switch should remain in
Setting
By Pass position.
Information
4) 12VDC
WHEN APPLICABLE
If you plan to power the
Cinénova using an
external source. Then
you will need to plug the
source into the 12VDC
Trigger.
When using this feature
the main power switch
must remain in the OFF
position at all times.
6) TURN ON CIRCUIT BREAKER
This amp is equipped
with a 20 ampere circuit
breaker. Once that all
tasks have completed
then proceed to turn the
circuit breaker to the on
position.