EarthQuake CS4518B Operator's Manual - Page 3
Browse online or download pdf Operator's Manual for Chainsaw EarthQuake CS4518B. EarthQuake CS4518B 3 pages.
(2) Any warranted, emissions-related part that is scheduled only
for regular inspection as specified in the Maintenance Schedule
(located in the section of the Manual(s) pertaining to maintenance)
shall be warranted for the ECS Warranty Period. A statement in such
written instructions to the effect of "repair or replace as necessary"
shall not reduce the ECS Warranty Period. Any such part repaired or
replaced under the ECS Warranty shall be warranted for the remain-
der of the ECS Warranty Period.
(3) Any warranted, emissions-related part that is scheduled for re-
placement as required maintenance in the Maintenance Schedule
(located in the section of the Manual(s) pertaining to maintenance)
shall be warranted for the period of time prior to the first scheduled
replacement point for that part. If the part fails prior to the first
scheduled replacement, the part shall be repaired or replaced by
Ardisam according to Subsection (4) below. Any such emissions-
related part repaired or replaced under the ECS Warranty shall be
warranted for the remainder of the ECS Warranty Period prior to the
first scheduled replacement point for such emissions-related part.
(4) Repair or replacement of any warranted, emissions-related part
under this ECS Warranty shall be performed at no charge to the
owner at a Ardisam Authorized Warranty Service Facility.
(5) When the engine is inspected by a Ardisam Authorized Warranty
Service Facility, the owner shall not be held responsible for diag-
nostic costs if the repair is deemed warrantable.
(6) Ardisam shall be liable for damages to other original engine
components or approved modifications proximately caused by a
failure under warranty of any emission-related part covered by the
ECS Warranty.
(7) Throughout the ECS Warranty Period, Ardisam shall maintain a
supply of warranted emission-related parts sufficient to meet the
expected demand for such emission-related parts.
(8) Any Ardisam authorized and approved emission-related
replacement part may be used in the performance of any ECS War-
ranty maintenance or repairs and will be provided without charge
to the purchaser/owner. Such use shall not reduce Ardisam's ECS
Warranty obligations.
(9) Unapproved, add-on, modified, counterfeit and/or "grey market"
parts may not be used to modify or repair a Ardisam engine. Such
use voids this ECS Warranty and shall be sufficient grounds for
disallowing an ECS Warranty claim. Ardisam shall not be held liable
hereunder for failures of any warranted parts of a Ardisam engine
caused by the use of such an unapproved, add-on, modified, coun-
terfeit and/or "grey market" part.
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
EMISSION-RELATED PARTS INCLUDE THE FOLLOWING
(IF EQUIPPED):
(1) Fuel Metering System
(i) Carburetor and internal parts (and/or pressure regulator or
fuel injection system).
(ii) Air/fuel ratio feedback and control system.
(iii) Cold start enrichment system.
(iv) Fuel Tank.
(2) Air Induction System
(i) Controlled hot air intake system.
(ii) Intake manifold.
(iii) Air filter.
(3) Ignition System
(i) Spark Plugs.
(ii) Magneto or electronic ignition system.
(iii) Spark advance/retard system.
(4) Exhaust Gas Recirculation (EGR) System
(i) EGR valve body, and carburetor spacer if applicable.
(ii) EGR rate feedback and control system.
(5) Air Injection System
(i) Air pump or pulse valve.
(ii) Valves affecting distribution of flow.
(iii) Distribution manifold.
(6) Catalyst or Thermal Reactor System
(i) Catalytic converter.
(ii) Thermal reactor.
(iii) Exhaust manifold.
(7) Particulate Controls
(i) Traps, filters, precipitators, and any other device used to cap-
ture particulate emissions.
(8) Miscellaneous Items Used in Above Systems
(i) Electronic controls.
(ii) Vacuum, temperature, and time sensitive valves and switch-
es.
(iii) Hoses, belts, connectors, and assemblies.
Operator's Manual
CS4518B Chainsaw
31