Award CS1-903S Instruction Manual - Page 3

Browse online or download pdf Instruction Manual for Ventilation Hood Award CS1-903S. Award CS1-903S 15 pages.

Print Page
Award CS1-903S Instruction Manual
 
SAFETY INSTRUCTIONS
 
T
hismanualexplainstheproperinstallationanduseofyourrangehood,please
readitcarefullybeforeusingevenifyouarefamiliarwiththeproduct.The
manualshouldbekeptinasafeplaceforfuturereference.
Nevertodo:
D
●
o not try to use the range hood
without the grease filters or if the filters
are excessively greasy!
D
●
o not install above a cooker with a
high level grill.
D
●
o not leave frying pans unattended
during use because overheated fats or
oils might catch fire.
N
●
ever leave naked flames under the
range hood.
I
●
f the range hood is damaged, do not
attempt to use.
D
●
o not flambé under the range hood.
C
●
AUTION: Accessible parts may
become hot when used with cooking
appliances.
T
●
he minimum distance between the
supporting surface for the cooking
vessels on the hob and the lowest part
of the range hood. (When the range
hood is located above a gas appliance,
this distance shall be at least 65 cm)
●
T
he air must not be discharged into a
flue that is used for exhausting fumes
from appliances burning gas or other
fuels.

 
Alwaystodo:
I
●
mportant! Always switch off the
electricity supply at the mains during
installation and maintenance such as
light bulb replacement.
T
●
he range hood must be installed in
accordance with the installation
instructions and all measurements
followed.
A
●
ll installation work must be carried
out by a competent qualified
electrician.
P
●
lease dispose of the packing material
carefully. Children are vulnerable to it.
P
●
ay attention to the sharp edges
inside the range hood especially
during installation and cleaning.
M
●
ake sure the ducting has no bends
sharper than 120 degrees as this will
reduce the efficiency of the range
hood.
W
●
arning: Failure to install the screws
or fixing device in accordance with
these instructions may result in
electrical hazards.
●
W
arning: Before obtaining access to
terminals, all supply circuits must be
disconnected.





3