Miele NOVOTRONIC W 1918 Operating Instructions Manual - Page 36

Browse online or download pdf Operating Instructions Manual for Washer Miele NOVOTRONIC W 1918. Miele NOVOTRONIC W 1918 48 pages. Miele washer user manual
Also for Miele NOVOTRONIC W 1918: Operating Instructions Manual (48 pages)

Print Page

1. Cleaning and Care

Plumbing Connections

Connect the cold water intake hose

(blue mark) to the cold water valve and

the hot water intake hose (red mark) to

the hot water valve.

Turn on the valves and check for leaks.

The water pressure must be within

15-145 psi (1-10 bar). If the water pres-

sure is greater than 145 psi

(10 bar), a pressure reducer must be

installed. If the water pressure is below

15 psi (1 bar), insufficient water may be

available for a complete fill.

The water intake hoses are equipped

with screen filters. Please do not re-

move these filters.

Please note

If the machine is being connected to a

cold water supply only, both the hot

and cold water intake hoses should be

attached to the cold water valve

through the use of a Y adapter (avail-

able at any hardware store). Both hoses

must be connected to a water source,

or the machine will not function prop-

erly. Do not connect the washer to hot

water only.

Drain connection

The 5 ft. (1.5 m) drain hose may be

connected as follows:

1 . Directly into a sink: hook the hose

over the edge of the sink and secure

it firmly (e.g. by tying the hose to the

water faucet).

2 . To a stand pipe: place the drain

hose into a 1

and firmly secure it.

3 . To a floor drain: The machine is

equipped with an airgap/anti-siphon-

ing system so that no minimum drain

height is required.

^ The machine drains using a pump

with a maximum delivery height of

4 ft. (1.2 m).

^ Make sure there are no kinks in the

drain hose.

^ If desired, the drain hose may be ex-

tended to 15 ft. (4.5 m) maximum.

" (38 mm) stand pipe