Miele DA 1260 Operating And Installation Instructions - Page 37
Browse online or download pdf Operating And Installation Instructions for Ventilation Hood Miele DA 1260. Miele DA 1260 44 pages.
Also for Miele DA 1260: Operating And Installation Instructions (44 pages), Operating And Installation Instructions (48 pages), Operating And Installation Instructions (44 pages)
Print Page
For recirculation mode
Fit the charcoal filter (see "Cleaning
and care").
Electrical connection
Refer to the notes in "Electrical
connection" and "Warning and
Safety instructions" before
connecting to the electricity supply.
Connect the cooker hood to the
electricity supply.
Functional check
To do this, switch the fan on.
- In air extraction mode air should not
come out of the recirculation grille at
the front of the cooker hood.
- In recirculation mode the air should
come out of the recirculation grille at
the front of the cooker hood.
If this does not happen, the deflector is
not installed correctly (see "Deflector").
Electrical connection
Refer to the notes in "Electrical
connection" and "Warnings and
safety notes" before connecting to
the power supply.
The connection data (voltage,
frequency) on the data plate must
match the data of the mains power
supply. The position of the data plate is
explained in the "Service" chapter.
The cooker hood is equipped with a
power cable and a safety plug.
The connection must be made via a
socket which remains accessible after
the cooker hood has been installed. If
the socket is no longer accessible after
installation or if you are using a hard-
wired connection, there must be a
suitable means of disconnection for all
poles in the household electrical system
which meets the requirements of
overvoltage category III.
Safety can be increased by fitting the
appliance with a residual current
device.
Only qualified electricians are permitted
to carry out work on the household
electrical system.
This appliance must be earthed.
Connection for air extraction
If the cooker hood is used at the
same time as a heating appliance
that relies on oxygen from the same
room, there is a risk in certain
circumstances of toxic fumes
building up.
It is essential that the "Warning and
Safety" instructions are observed.
The cooker hood should be installed
according to local and national
building regulations. Seek approval
from the building inspector where
necessary.
Only use smooth pipes or flexible
exhaust ducting made from
approved non-flammable materials
for exhaust ducting.
To achieve the most efficient air
throughput with the lowest noise levels,
please note the following:
Installation
37