Miele DA 196-2 Operating And Installation Manual - Page 12
Browse online or download pdf Operating And Installation Manual for Ventilation Hood Miele DA 196-2. Miele DA 196-2 32 pages. Cooker
Print Page
^ To remove a grease filter, press the
locking clips towards the middle of
the filter.
^ Remove the filters.
^ Clean the filters:
with a nylon brush in warm
water with a little washing up liquid.
with the short side upright in the
lower basket, ensuring the spray arm
is not obstructed.
Depending on the cleaning agent
used, cleaning the grease filters in a
dishwasher can cause permanent
discolouration to the surface of the
filters. However, this will not affect
the functioning of the grease filters in
any way.
^ After cleaning leave the filters to dry
for a while on an absorbent surface
before putting them back in place.
^ When removing the filters for clean-
ing also clean off any residues of oil
or fat from the now accessible hous-
ing to prevent the risk of these catch-
ing fire.
12
place the filters
^ When replacing the grease filters
make sure the locking clips are visi-
ble facing down towards the hob.
Should the grease filters be put back
upside down:
insert a small screwdriver into the
slits to disengage them. Do not let
them drop on to the hob below.
If the cooker hood is connected for
recirculation two active charcoal filters
must be inserted in addition to the
grease filters. These filters absorb nor-
mal kitchen odours.
They are fitted in the canopy above the
grease filters.
Active charcoal filters can be ob-
tained from your dealer or the Miele
Spare Parts Department.
Refer to the section "Technical data"
for type and reference number.
The filters are supplied with fitting instruc-
tions. Ensure these are carefully followed.
Replace the filters when they no longer
absorb kitchen odours effectively.
They should, however, be replaced at
least every 6 months.