Miele DA 249-4 Operating And Installation Instructions - Page 21
Browse online or download pdf Operating And Installation Instructions for Ventilation Hood Miele DA 249-4. Miele DA 249-4 40 pages. Ventilation system
Also for Miele DA 249-4: Operating And Installation Instructions (40 pages), Operating And Installation Instructions (40 pages), Operating And Installation Instructions (44 pages)
Print Page
,
Before any cleaning or
maintenance work is carried out,
disconnect the rangehood from the
mains supply. Ensure that:
– it is switched off at the wall
socket and the plug removed, or
– the mains fuse is withdrawn, or
– the screw-out fuse is removed
(in countries where this is
applicable).
,
Exercise caution when changing
halogen lamps. They get very hot
during use, and remain hot for some
time after being switched off. Do not
touch the surface directly when
changing a lamp, as grease particles
from your fingers will adhere to the
surface and damage it.
The halogen lamps can also be
damaged if water is used to clean
them.
Wait several minutes after switching
off before beginning cleaning.
A range of Miele branded cleaning and
conditioning agents are available to
order through your Miele Chartered
Agent, from Miele, or via the internet at
www.miele-shop.com.
Original Miele all purpose microfibre
cloth
^ The Original Miele all purpose
microfibre cloth is available from Miele
and at www.miele-shop.com and is
suitable for cleaning surfaces such as
stainless steel, glass, plastic and
chrome without the use of chemicals.
It can be washed 300 times.
Cleaning and care
Housing
General notes
The surfaces and controls are
susceptible to scratches and
abrasions. Please observe the
following cleaning instructions.
^ All external surfaces and controls can
be cleaned using the Original Miele
all purpose microfibre cloth, or with
warm water and a small amount of
washing-up liquid applied with a well
wrung-out soft sponge or cloth.
^ Wipe the surfaces dry using a soft
cloth.
Do not use too much water when
cleaning the controls. Water could
penetrate into the electronics and
cause damage.
Do not use any of the following to clean
any surfaces:
– cleaning agents containing soda,
acids, chlorides or solvents,
– abrasive cleaning agents, e.g.
powder cleaners and cream
cleaners.
– abrasive sponges, e.g. pot scourers,
or sponges which have been
previously used with abrasive
cleaning agents.
Please note the following advice for
cleaning different surfaces.
21