Miele DA 327 i Operating And Installation Manual - Page 26
Browse online or download pdf Operating And Installation Manual for Ventilation Hood Miele DA 327 i. Miele DA 327 i 40 pages.
Print Page
Appliance fitted with a lightshield to
match the kitchen furniture:
To calculate the position of the light-
shield:
Measure the distance "B" from the
front of edge of the wall unit (without
door) and the rear edge of your light-
shield.
Then draw a vertical line approx. 20
cm long on both the left and right
side panels of the wall unit for dimen-
sion "C".
If dimension "B" is less than 20 mm,
dimension "C" will be 100 mm.
If dimension "B" is between 20 and 40
mm, dimension "C" will be 124 mm.
If the appliance is fitted into a Miele kit-
chen furniture wall unit and fitted with a
lightshield to match, the necessary drill
holes will already be provided in the
wall unit.
26
(Standard wall unit: 60 cm wide, 16 mm
thick carcase sides)
Hold the runner against the wall unit
ensuring that the lower edge of the
runner is flush with the wall unit. The
first row of screws must be aligned
against the marked line.
The "16 mm" marking should face up-
wards.
Secure each runner with four 40 x 16
mm screws.
Exception: Please refer to the notes
under "Special fitting instructions" at
the end of the "Installation" section for
instructions on fitting the appliance into
a wall unit with 19 mm thick carcase
sides or into a 70 cm or 90 cm wide
wall unit.
Before building in the
appliance, fit and
align the wall unit fur-
niture door.
Use the special tool
supplied, if you need
to re-align the furni-
ture door after the ap-
pliance has been
built in and the
hinges are no longer accessible.