Miele DA 403 Operating And Installation Instructions - Page 18

Browse online or download pdf Operating And Installation Instructions for Ventilation Hood Miele DA 403. Miele DA 403 32 pages. Ventilation system
Also for Miele DA 403: Operating And Installation Instructions (32 pages), Product Dimensions (2 pages), Install Manual (2 pages), Operating And Installation Manual (36 pages), Operating And Installation Instructions (36 pages), Operating And Installation Instructions (36 pages)

Print Page
Miele DA 403 Operating And Installation Instructions
The reusable metal grease filters
remove solid particles from the vented
kitchen air (grease, dust, etc).
The grease filters should be cleaned
every 3 - 4 weeks or when the grease
filter indicator lights.
A dirty filter is a fire hazard.
^ To remove the grease filters pull the
locking clips, , forward. Lower the
filter 45°, , unhook it at the rear, ,
and take it out. Support the grease
filter so that it does not fall onto the
cooktop.
18
^ -
use a scrub brush in
warm water with a mild detergent.
-
vertically in the lower basket, making
sure that the spray arm is not
blocked. Wash using the "Sani Wash"
or "Normal Plus" programs.
Depending on the detergent,
cleaning the grease filters in a
dishwasher may cause permanent
discoloration of the filter surface.
Performance of the filter will not be
affected by this discoloration.
^ After cleaning, the filters can be
placed on a towel to air dry.
^ While the filters are removed, clean
any dirt or grease from the filter
casing to prevent the risk of fire.
When putting the grease filters back
make sure that the locking clips are
visibly facing the cooking surface.
If the filters are incorrectly installed,
insert a small screwdriver into the slit
along its edge to disengage it from the
casing.
^ After returning the grease filters,
press and hold the grease filter
button for 3 seconds to reset the
timer. The indicator light will go out.
^ If the grease filters are cleaned
before the grease filter timer has
reached its maximum, press the
grease filter button for 6 seconds to
reset the counter to zero.
place the filters