Miele DA 428-4 EXT Operating And Installation Manual - Page 22

Browse online or download pdf Operating And Installation Manual for Ventilation Hood Miele DA 428-4 EXT. Miele DA 428-4 EXT 40 pages. Cooker
Also for Miele DA 428-4 EXT: Operating And Installation Manual (40 pages), Operating And Installation Instructions (40 pages)

Miele DA 428-4 EXT Operating And Installation Manual
Cleaning and care
Cleaning the grease filters by hand
^ Clean the filters with a soft nylon
brush in a mild solution of hot water
and a small amount ofwashing-up
liquid.
Do not use:
– cleaning agents containing
descaling agents,
– powder cleaners, cream cleaners or
abrasive all-purpose cleaning
agents,
– oven sprays.
Cleaning the grease filters in the
dishwasher
^ Place the filters as upright as
possible in the lower basket, with the
short sides upright. Make sure that
the spray arm can move freely.
^ Do not wash at more than 65° C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^ Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
22
^ When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of these
catching fire.
When putting the grease filters back in
position, ensure that the locking clips
are facing down towards the hob.
^ If the grease filters are inadvertently
replaced upside down, insert a small
screwdriver blade into the slits to
disengage the clip.
^ After replacing the grease filters,
press the grease filter touch control
for approximately 3 seconds to re-set
the operating hours counter.
The indicator lamp will go out.
If the grease filters are cleaned before
the operating hours counter has
reached its maximum, the grease filter
touch control should be pressed for
approximately 6 seconds to reset the
counter.