Allmatic XTILUS 24V Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Garage Door Opener Allmatic XTILUS 24V. Allmatic XTILUS 24V 7 pages. Irreversible gearmotor for wing gates

Print Page

FIXING OF THE REAR PLATE TO THE COLUMN

Fix the rear plate to the column (Fig. 4) in accordance to the desired coordinates.

In case an iron pillar is available, screw directly onto the column the plate with

3 screws M8..

In case you need to fix the bracket onto a concrete pillar, use the fixing plate to

be fastened with 3 Fischer screws of Ø 8 mm.

When the backing plate is fixed, anchor the rear part of the piston to the plate

and fasten it firmly (Fig. 6).

ATTENTION: when establishing the height off the ground at which to fasten

the plate to the pillar (Fig. 4), keep in mind that the plate for anchoring

the piston to the gate must be fastened 40 mm below that on the post to

obtain horizontal levelling (Fig. 5).

Motor

FIXING OF THE FRONT PLATE TO THE GATE

For the fixing of the front plate to the leaf, follow this procedure:

Fit the anchor plate onto the piston. Insert the washer, tighten the bolt

firmly (Fig. 7).

ATTENTION: lubricate the hole of the front plate and the towing of the

motor with silicone grease before the fixing.

Close the gate.

Move the piston with the plate already fitted towards the gate.

Move the stem to the limit stop, then move it back by approximately 1 cm

and mark the position of the plate.

Realize the same operation in opening.

If positions correspond, fix the plate on the gate; otherwise revise A and B

coordinates (TABLE 1).

N.B.: during the installation, try several times to open and to close the gate,

controlling that the gearmotor does not touch the moving gate

ADJUSTMENT OF MECHANICAL LIMIT SWITCH - OPTIONAL

The gearmotor may be provided with mechanical limit switches, optional, in

opening and/or closing, if the gate is not fitted with a floor stop (Fig. 8).

To adjust, slacken the screws on the limit switch and move it to the desired

position. Lock the screws (Fig. 9).

FINAL CHECK OF THE INSTALLATION

Before to proceed with the electrical cabling of the motor, check the correct

movement of the gate:

Unlock the motor and move manually the wing of the gate.

If the wing moves easily, the installation is correct. Otherwise lubricate the

hinges, the hole in the front plate and the towing of the gate. Check the

correct installation of the motor.

MAINTENANCE

To be carried out exclusively by skilled persons after the power supply to

the motor has been interrupted.

Lubricate the hinges, the hole of the front plate, the towing of the motor and

check the thrust force generated by the gearmotor on the gate once a year.

Lubricate the nut screw with silicone grease every two years.

10/20

ATTENTIONE: use a level

for the positioning of the

Plate

Seeger

FIG. 6

ITA

ENG

Front plate

plates.

FRA

ESP

DEU

POR

Rear plate

TIGHTEN

FIRMLY

www.remotecontrolgates.co.uk 01482 860950

FIG. 4

FIG. 5

FIG. 7

FIG. 8

FIG. 9