Allmatic B.RO X40 DISPLAY Manual - Page 8

Browse online or download pdf Manual for Receiver Allmatic B.RO X40 DISPLAY. Allmatic B.RO X40 DISPLAY 20 pages. 4 channels rolling code receiver, with display

Print Page

PARAMETERS FOR OUTPUTS

Sub-menu where you can:

rtIme

- set the activation time of the output with the Timed function or

Timed+Delay function (LiFE);

- set the delay time for the Timed+Delay function (dLy).

RESET OF THE PARAMETERS

def

It restores the receiver to default settings.

4.1.1 PWD - PASSWORD

The menu of the receiver can be protected by a password that will be requested at every login attempt.

This is shown in the display with P0000 and the ﬁ rst digit blinking. To change the digit you can use the UP (+) and DOWN (-) buttons.

To move to the next digit press brieﬂ y the MENU button. At the end of the procedure, if the password is correct you will enter the

menu, otherwise the display will show: P Err.

After 1 minute of inactivity the password will be re-enabled.

ATTENTION: it is not possible to delete a forgotten password. You will need a recovery procedure by the manufacturer.

4.1.2 Heyb - LEARNINGS

It is possible to enable or disable all the learnings. These are the only active functionality that does not require a password (if

enabled): in this way you add a further degree of protection to the receiver.

4.1.3 HIde - HIDDEN KEY (only with biroL coding)

It is possible to enable or disable the hidden button of the transmitters. This button allows you to enter the sequential learning/

delete the remote control.

4.1.5 Input - WIRED INPUTS PARAMETERS

It allows to associate to each wired input an output function.

There are 4 different functions:

- 0: Dead Man;

- 1: Step by step;

- 2: Timed;

- 3: Timed + Delay.

To change the parameter please follow the procedure below:

Select the desired function with the UP (+) and DOWN (-) buttons of the receiver.

8/20

DESCRIPTION

Go to the menu item Input.

Select the wired input using the UP (+) and DOWN (-) buttons of the receiver.

Press and hold the MENU button

Press and hold the MENU button until the parameter blinks.

Conﬁ rm the change with a long pressure of the MENU button.

ITA

ENG

The display shows:

until the display shows:

FRA

ESP

DEU

SELECTABLE

VALUES

DEFAULT

min-max

LiFE

1-65535

dLy

0-255

POR

6-1620020

rev.0

UNIT

27/10/2015