Miele HS08 Operating Instructions Manual - Page 15
Browse online or download pdf Operating Instructions Manual for Vacuum Cleaner Miele HS08. Miele HS08 23 pages.
Print Page
For normal vacuum cleaning the
telescopic tubes must be pushed
back together. Make sure the
handle is also correctly hooked into
its holder on the cleaner (see detail
in dia. 19).
Using the Electrobrush
Recommended use
Please observe the flooring
manufacturer's cleaning and care
instructions.
The Electrobrush is particularly suitable
for intensive vacuuming of carpets
which are subject to hard wear. It is
very effective at removing deep seated
dirt and preventing areas of frequent
use being trodden into a path.
,
Please note that the
Electrobrush should not be used for
vacuuming deep-pile rugs and
carpets or valuable hand-knotted
rugs and carpets, e.g. Persian and
oriental rugs etc. There is a danger
of the threads being pulled out. If in
doubt, contact the carpet
manufacturer/retailer.
,
Do not use the Electrobrush to
clean highly variable or uneven
floors. The brush might come into
contact with the floor and cause
damage.
Switching the Electrobrush on and
off (dia. 21)
To use the Electrobrush, you need to
switch it on in addition to the vacuum
cleaner with the Carpet button on the
handle.
The Electrobrush indicator light on the
control unit will light up yellow.
This button also enables you to switch
off the Electrobrush during vacuuming.
The Electrobrush will switch itself off
automatically as soon as the
vacuum cleaner is raised to its up-
right position.
How to use the Electrobrush
^ To achieve the best results, pass the
Electrobrush slowly backwards and
forwards over the carpet or floor.
For rugs and carpets with fringes
always draw the Electrobrush from the
middle of the rug or carpet across the
fringe towards the floor.
Using the accessories
supplied (dia. 22)
The following accessories are stowed
at the back of the vacuum cleaner.
a Upholstery nozzle
b Crevice nozzle, 300 mm
c Dusting brush with natural bristles
^ Attach the accessory required onto
the suction hose handle or onto the
telescopic tube.
en
39