en
How to change the battery in the
radio-control handle
^ Open the cover to the battery
compartment using a screwdriver.
^ Replace with a new battery, making
sure the polarity is correct.
^ Replace the cover.
^ Dispose of the old battery
responsibly.
When to change the thread lifters
The thread lifters on the suction inlet to
the floorhead can be replaced.
Check them from time to time and
replace them if the pile has worn down.
How to replace the thread lifters
(dia. 42 + 43)
^ Use a suitable screwdriver to remove
the thread lifters from the slots.
^ Fit new thread lifters.
Upholstery nozzle SPD 10
(depending on model) (dia. 44)
^ Disengage the thread lifter unit at
each side of the upholstery nozzle
using a coin.
^ Fit a new thread lifter unit and lock
into position.
How to clean the roller on floorhead
SBD 285 AllTeQ (dia. 45)
a Release the bearing (with bayonet
fitting) using a coin.
b Press the bearing out, and remove.
c Remove the roller.
46
^ Remove any threads and hair,
replace the roller and refit the
bearing, locking it back into position.
Replacement parts are available from
your Miele Dealer or from Miele (see
end of booklet for contact details).
Cleaning and care
,
Always disconnect the vacuum
cleaner from the electrical supply
before cleaning it. Switch off at the
wall socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic
accessories can be cleaned with a dry
or a slightly damp cloth, or with a
proprietary cleaner suitable for plastic.
,
Do not use abrasive cleaning
agents, glass cleaning agents,
all-purpose cleaners or oil-based
conditioning agents.
Dust compartment
The dust compartment can, if
necessary, be cleaned using a dry
duster, brush or, if available, a second
vacuum cleaner to vacuum the dust
out.
,
Do not let the vacuum cleaner
get wet. If moisture gets into the
appliance, there is a risk of electric
shock.
Print Page