Miele K 12820 SD edt Operating And Installation Instructions - Page 34
Browse online or download pdf Operating And Installation Instructions for Refrigerator Miele K 12820 SD edt. Miele K 12820 SD edt 48 pages. Refrigerator with dynamiccooling
Also for Miele K 12820 SD edt: Operating And Installation Manual (48 pages), Operating And Installation Manual (40 pages), Operating And Installation Instructions (44 pages), Operating And Installation Instructions (44 pages)
Print Page
Electrical connection
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
local and national safety regulations.
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an AC single phase
220 – 240 V 50 Hz supply.
The fuse rating must be at least 10 A.
The voltage and frequency are given on
the data plate. Please ensure that these
match the household mains supply.
Connection should be made via a
suitable switched socket which is easily
accessible. For extra safety it is
advisable to install a suitable residual
current device (RCD).
The accessibility of the plug must
always be ensured in order to be able
to quickly separate the appliance from
the mains.
If the mains socket is not accessible
after the appliance has been built in, a
separator for each terminal must be
available. There must be an all-pole
contact gap of 3 mm in the switch.
The plug and mains connection cable
must not come into contact with the
back of the appliance as vibrations can
cause damage to these components.
This, in turn, could result in a short
circuit.
Nor should other appliances be
plugged into a socket located directly
behind the wine conditioning unit.
34
Do not connect the appliance to the
mains electricity supply by an extension
lead or a plug adapter. Extension leads
do not guarantee the required safety of
the appliance (e.g. danger of
overheating).
Do not connect the appliance to an
inverter such as those used with an
autonomous energy source e.g. Solar
power.
When switched on, peak loads in the
system can cause the safety switch off
mechanism to be triggered. This can
damage the electronic unit.
The machine must not be used with
so-called energy-saving devices
either. These reduce the amount of
energy supplied to the machine,
causing it to overheat.
If the mains connection cable needs to
be replaced, this must only be carried
out by a qualified electrician.
WARNING
THIS APPLIANCE MUST BE
EARTHED