Miele GAS COMBISET CS 1012 Operating And Installation Instructions - Page 40

Browse online or download pdf Operating And Installation Instructions for Cooktop Miele GAS COMBISET CS 1012. Miele GAS COMBISET CS 1012 44 pages. Double gas combiset
Also for Miele GAS COMBISET CS 1012: Operating And Installation Instructions (44 pages), Product Dimensions (4 pages), Converting Instructions (40 pages)

Miele GAS COMBISET CS 1012 Operating And Installation Instructions
Gas connection

Gas pressure regulator

A pressure regulator that is convertible
from natural to LP gas (Propane) or vice
versa is included with the appliance.
The included regulator corresponds
with the gas type of the combiset. Verify
before installing.
The adjusted pressure is:
natural gas - 4" w.c.
LP gas - 10" w.c.
a Combiset
b ½" NPT
c Regulator
As shown in the above diagram, the
included regulator must be used when
connecting the Miele combiset to your
gas supply. This item has been
customized by Miele to meet all
applicable safety requirements. Make
sure the regulator is easily accessible
for adjustment after the appliance has
been installed.
40
For convenience, an AGA or CGA
approved flexible stainless steel gas
hose (accordion type) may be used
between the gas connection and the
regulator. This will allow the appliance
to be lifted out of the countertop for
cleaning or servicing. Make sure that
any drawers, cabinet doors, etc., do not
rub on this gas hose.
Do not use any regulator unless it
has been supplied by Miele. Doing
so may cause a gas leak.
If there is any doubt concerning
installation contact the Miele Technical
Service Department.
After connecting the appliance check
all fittings for gas leaks e.g. with
soapy water.
When installed properly, the flame will
be steady and quiet. It will also have a
sharp, blue inner core that will vary in
length proportional to the burner size.
Flame adjustment will not be
necessary.