ALLNIC AUDIO HA-5000 Owner's Manual - Page 8
Browse online or download pdf Owner's Manual for Amplifier ALLNIC AUDIO HA-5000. ALLNIC AUDIO HA-5000 12 pages. Pre-preamplifier (head amplifier)
Also for ALLNIC AUDIO HA-5000: Owner's Manual (7 pages)
Print Page
•
turned the volume down on or muted the preamplifier or integrated amplifier to which you
have connected your HA-5000
checked that all your connections are snug
•
Turn on the HA-5000 by pressing the button on the front panel of the power supply unit down
to the "on" position.
The running LEDs on the fronts of both the power supply and the pre-preamplifier unit will
illuminate.
The Allnic Audio HA-5000 is now ready for operation.
OPERATION
At this point, if you have not already done it, turn the front panel load selection control knob to
the loading factor that you think will work best for your moving coil cartridge.
The HA-5000 has four input load impedances: 50, 100, 200, and 500 ohms, selectable from a
control on the front panel (see Figure 4). You may need to experiment with different load
settings to find the one best suited for your cartridge.
From this point on, operation is straight-forward. Of course, always be sure you have turned the
volume down to zero or otherwise muted your preamplifier or integrated amplifier before
changing loads with the front panel control.
In the case of any failure, please contact your Allnic Audio dealer.
TUBES
The HA-5000 uses the following tubes (see Figure 5):
2 x Nuvistor 7895 (equivalent 6CW4)
•
2 x 7233 (no equivalent)
•
•
2 x 6BH6 (equivalent CV3908)
All consequences of changing or attempting to change tubes are borne by the user unless by
express agreement between the owner and Allnic Audio or its authorized representative. Allnic
Audio and its authorized representatives are not liable in any way whatsoever for any injury or
loss incurred by the user or for damage to the HA-5000, any of its parts, or tubes or replacement
tubes resulting from the user changing or attempting to change tubes.
8