Allo RemoteControl NICE HSCU2C Instructions Manual

Browse online or download pdf Instructions Manual for Remote Control Allo RemoteControl NICE HSCU2C. Allo RemoteControl NICE HSCU2C 8 pages.

Print Page

NICE HSCU2W, HSCU2C, HSCU2GW, HSCU2GC

Setting up the system components for configuration:

Since the system components communicate wirelessly, it is best to configure the system first on the

bench and only then locate and install the devices. For control panels which also have electrical

connections, proceed as follows:

1) configure the wireless devices on the bench;

2) mount all devices;

3) make the electrical hookup. To avoid errors, malfunctions and reception failures, proceed as follows:

a) Place all products on the bench with their packaging open;

b) Insert the "SIM" card for the GSM version (see figure 10); Caution - the SIM card's PIN must be

cancelled, along with any messages, contacts and other resident or saved information. Caution - 3G

SIM cards are not compatible.

c) Power up the control panel and program it - "Alarm system programming");

d) Insert the batteries into the devices so that the control panel can acquire them one by one;

e) Test the operation of the various devices;

f) Place the control panel in its intended location (do not mount it there yet);

g) Place the other devices in their intended positions (again, without mounting them yet);

h) Check that every device has sufficiently wireless reception to operate (see "Testing the control

panel"); In GSM models, check that there is sufficient reception:

i) Now install all devices in place; The following paragraphs describe the installation of the control

panel (all models) and the electrical hookup of wired versions.

Preliminary checks before installation and limitations on use:

Before proceeding with installation, check the condition of the product, suitability of the selected model

and conditions of the intended installation environment.

• Check that all conditions fall within the "limits of use" and "technical characteristics".

• Check that the installation location is compatible with the overall clearance of the product.

• Check that the mounting surface is solid, so that the device is mounted securely and is protected

against impact.

• Install the control panel at least 1 m off the ground. • the product may only be used with Nice Home

Security system devices

Visit our website: www.Alloremotecontrol.com

INSTRUCTIONS