Dialighting LED-PAR64-3W-RGB User Manual - Page 4

Browse online or download pdf User Manual for DJ Equipment Dialighting LED-PAR64-3W-RGB. Dialighting LED-PAR64-3W-RGB 6 pages. Led par

Print Page
Data Cable (DMX Cable) Requirements (For
DMX and Master/Slave Operation):
The PAR CAN can be controlled via DMX-512
protocol. It is a 4/7 channel DMX unit. The
DMX address is set below the dome of this PAR
light.Your unit and your DMX controller require
a standard 3-pin XLR connector for data input
and data output (Figure 1). If you are making
your own cables, be sure to use standard two
conductor shielded cable (This cable may be
purchased at almost all pro sound and lighting
stores). Your cables should be made with a male and female XLR connector
on either end of the cable. Also remember that DMX cable must be daisy
chained and can not be split
.
Notice:
Be sure to follow figures two and three when making your own cables.
Do not use the ground lug on the XLR connector. Do not connect the
cable¡s shield conductor to the ground plug or allow the shield conductor
to come in contact with the XLR¡s outer casing. Grounding
the shield could cause a short circuit and erratic behavior.
XLR Male Socket
XLR Male Socket
1Ground
2Cold
2Cold
3Hot
3Hot
Figure1
Figure2
X L R P i n C o n f i g u r a t i o n
pin1=Ground
1Ground
pin2=Data Compliment(negative)
pin3=Data true(positive)
System Menu
DMX 4Channels & Functions
Closed
0
1CH
R
1-255
Closed
0
2CH
G
1-255
Closed
0
3CH
B
1-255
Closed
0-7
Adjust general brightness
8-200
4CH
201-247
Strobe effect is from slow to fast
Full brightness
248-255
DMX 7 Channels&Functions:
1CH
0
Closed
1-255
2CH
0
1-255
3CH
0
1-255
4CH
0
Ad
1-255
5CH
0-9
10-248
Color change
249-255
Full brightness
6CH
0-9
Closed
10-255
Strobe effect is from slow to fast
7CH
0-127
128-255
R
Closed
G
Closed
B
Closed
Djust general brightness
Full brightness
Closed
Sound control