Alloy AS2024-P User Manual - Page 3

Browse online or download pdf User Manual for Switch Alloy AS2024-P. Alloy AS2024-P 16 pages. Fast ethernet and gigabit ethernet poe+ unmanaged switches

Print Page

Compliances and Safety Statements

Federal Communications Commission (FCC) Statement

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

•

Increase the separation between the equipment and receiver

•

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected

Consult the dealer or an experienced radio/TV technician for help

•

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired

operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate this equipment.

European Community (CE) Electromagnetic Compatibility Directive

This information technology equipment complies with the requirements of the Council

Directive 89/336/EEC on the Approximation of the laws of the Member States relating to

Electromagnetic Compatibility and 73/23/EEC for electrical equipment used within certain

voltage limits and the Amendment Directive 93/68/EEC. For the evaluation of the

compliance with these Directives, the following standards were applied:

RFI Emission:

- Limit according to EN 55022:2010 AS/NZS CISPR 22:2009, Class A

- Limit for harmonic current emission according to EN 61000-3-

2:2006+A1:2009+A2:2009

- Limitation of voltage fluctuation and flicker in low-voltage supply

system according to EN 61000-3-3:2008

Immunity:

- Product family standard according to EN 55024:2010

- Electrostatic Discharge according to IEC 61000-4-2:2008

- Radio-frequency electromagnetic field according to IEC 61000-4-

3:2006+A1:2007+A2:2010

- Electrical fast transient/burst according to IEC 61000-4-4:2010

- Surge immunity test according to IEC 61000-4-5:2005

- Immunity to conducted disturbances, Induced by radio-frequency

fields: IEC 61000-4-6:2008

- Power frequency magnetic field immunity test according to IEC

61000-4-8:2009

- Voltage dips, short interruptions and voltage variations immunity test

AS1000 & AS2000 User Manual