Dialogic IMG 1004 Quick Start Manual - Page 4

Browse online or download pdf Quick Start Manual for Gateway Dialogic IMG 1004. Dialogic IMG 1004 8 pages. Integrated media gateway
Also for Dialogic IMG 1004: Quick Start Manual (10 pages), Quick Start Manual (10 pages)

Print Page

Quick Start Guide Overview - IMG 1004

Topic Location: IMG1004-Quick Start Guide

Overview

This IMG 1004 Quick Start Guide is an abbreviated guide which explains how to connect power and network cabling. For

more information on setup please either refer to the "IMG 1004-Installation and Setup Guide" on the Technical Publications

CD supplied or go to the Dialogic Technical Support website at

installing and setting up the IMG 1004 and Dialogic GCEMS.

NOTE

To access the Dialogic Technical Support website, you will need a username and password. To obtain a username

and password, you will need a support contract with Dialogic. Once a support contract is obtained a username and password

will be supplied via email.

Shipping Information

Review the packing list to check that all the items listed on the packing list have been sent. Should any discrepancies exist,

contact your Dialogic Representative immediately.

Connecting AC Power

Power Specifications

The AC input power must conform to the specifications in the table below. Insert one end of AC cord into rear of IMG 1004

and the other end into a grounded wall outlet, uninterruptible power supply (UPS), or surge protector.

Power

Frequency

AC Power Module

The IMG 1004 provides an AC input power module with an integrated fuse, power switch, and standard three position female

AC input connector. This connector allows the IMG 1004 to interface with all variations of AC outlets by simply using a

standard power cable and compatible outlet plug.

Configuring Linux on GCEMS server

IMPORTANT

Please read and understand the IMG 1004 technical documentation prior to performing any setup or

installation procedures. The documentation can be accessed at:

If the IMG 1004 was purchased with the GCEMS Server then the Linux Red Hat Operating System

and GCEMS application have already been installed. Downloading System Software to the IMG 1004

will be the next step to getting the IMG 1004 configured. See topics under the following heading.

 IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup

If server was not purchased, then one must be configured with Red Hat Enterprise Linux. The IMG

1004 supports Red Hat Enterprise Linux 3, Red Hat Enterprise Linux 4 and Red Hat Enterprise Linux

5. Refer to the individual topics located under each of the following headings in the Online

Documentation for more information on configuring the Linux Server.

 IMG 1004-Installation and Setup Guide > IMG 1004-Linux Red Hat Installation

 IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup

 IMG 1004-Installation and Setup Guide > IMG 1004-SD Card

 Configuring Services on GCEMS Server

Dialogic Corporation

IMG 1004 Quick Start Guide

http://www.dialogic.com/support

120 – 240 VAC / 1.5 - 3 Amps

50 or 60 Hz

http://www.dialogic.com/support

Part # 07-8724-00

for detailed information on

Operating Range

90 – 240 VAC

50-60 Hz

Page 4 of 7