AllPondSolutions EFX+ Manual - Page 6

Browse online or download pdf Manual for Aquariums AllPondSolutions EFX+. AllPondSolutions EFX+ 20 pages. Aquarium external filters

Print Page

You must also make sure that the strainer on your inlet pipework is at least 7.5cm (3

inches) from the bottom of the tank. If your water intake pipe is too long, you will need to

cut the pipe with a hacksaw to the desired length, before replacing the strainer. Once it is

correctly positioned, secure the suction cup against the tank glass to hold in place.

7. Once you have your ﬁlter in place and its hoses securely attached to your aquarium

you are ready to prime the ﬁlter. Using the palm of your hand, push the blue button

directly on top of the motor head as far down as it will allow you to and repeat if

necessary, until the output hose has ﬁlled with water. You are now ready to plug your

external ﬁlter in.

– to prevent any damage to you unit, ensure the canister is

IMPORTANT!

completely full of water before the unit is switched on.

Water should ﬂow constantly from the output – if it does NOT, check to conﬁrm

the following:

 The canister cover is fully closed

 Any kinks or slack in the hose have been removed

 The water level in the tank is not more than 17.5cm (7 inches) below the tank rim

 The base of the unit is not more than 1.4m (4.5 ft) below the tank water level

 There is no air bubbling or water escaping from where the water intake or return

pipes are connected to the hose

 The hose adapters are ﬁxed securely into the ﬁlter motor head.

 The inlet pipe is securely attached to the aquarium wall with the suction cup

EF1+/EF2+

EFX+