Miller Axcess 300 Owner's Manual - Page 23

Browse online or download pdf Owner's Manual for Welding System Miller Axcess 300. Miller Axcess 300 36 pages. Arc welding power source and wire feeder with meters
Also for Miller Axcess 300: Owner's Manual (44 pages), Owner's Manual (48 pages)

Print Page
Miller Axcess 300 Owner's Manual

4-4. Changing Drive Roll and Wire Inlet Guide

Tools Needed:
5/64 in
7/16 in

4-5. Aligning Drive Rolls and Wire Guide

Tools Needed:
3
2
1
4
Correct
4
3
2
1
5
Incorrect
5
1
Securing Screw
2
Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
3
Anti-Wear Guide
Install guide as shown.
4
Drive Roll
Install correct drive roll for wire size
and type.
5
Drive Roll Securing Nut
Turn nut one click to secure drive
roll.
ST-150 227-C
Y Turn Off power.
View is from top of drive rolls look-
ing down with pressure assembly
open.
1
Drive Roll Securing Nut
2
Drive Roll
3
Wire Guide
4
Welding Wire
5
Drive Gear
Insert screwdriver, and turn screw
in or out until drive roll groove lines
up with wire guide.
Close pressure roll assembly.
Ref. ST-800 412-A
OM-1317 Page 19