Miller Axcess 300 Owner's Manual - Page 15

Browse online or download pdf Owner's Manual for Welding System Miller Axcess 300. Miller Axcess 300 48 pages. Arc welding power source and wire feeder with meters
Also for Miller Axcess 300: Owner's Manual (36 pages), Owner's Manual (44 pages)

Print Page
Miller Axcess 300 Owner's Manual

3-5. Selecting A Location

Movement
Location
Y Special installation may be required where gasoline or volatile
liquids are present − see NEC Article 511 or CEC Section 20.
18 in
(460 mm)

3-6. Connection Diagram

2
7
8
6
OR
1
4
3
4
1
9
Y Do not move or operate
Tipping
2
3
18 in
(460 mm)
5
unit where it could tip.
Y Do not stack units. Beware of
tipping.
1
Lifting Forks
Use lifting forks to move unit.
Extend forks beyond opposite side
of unit.
2
Hand Cart
Use cart or similar device to move
unit.
3
Rating Label
Use rating label to determine input
power needs.
4
Line Disconnect Device
Locate unit near correct input
power supply.
loc_2 3/96 -803 667-A
1
Welding Power Source
2
Wire Feeder
3
Gas Cylinder
4
Gas Hose
5
Network Feeder Cable
6
Negative (−) Weld Cable
7
Workpiece
8
Voltage Sensing Lead
Recommended for Accu-pulse and
RMD (optional).
.
Positive (+) voltage sensing
lead is contained in the motor
cable.
9
Positive (+) Weld Cable
803 667-A / Ref. 801 915-A
OM-216 967 Page 11