Miller Axcess 300 Owner's Manual - Page 29

Browse online or download pdf Owner's Manual for Welding System Miller Axcess 300. Miller Axcess 300 48 pages. Arc welding power source and wire feeder with meters
Also for Miller Axcess 300: Owner's Manual (36 pages), Owner's Manual (44 pages)

Print Page
Miller Axcess 300 Owner's Manual

5-1. Front Panel Switches

2
1
1
Power Switch
Turns unit On or Off.

5-2. Options

A. E-Stop Option
The E-Stop option comes with a 2-pin amphenol receptacle, matching plug, and 30 ft (9 m) of high density molded cord
to allow connecting the welding power source into an E-Stop circuit. An integrator will need to supply a closure for the
non E-Stop condition.
When the E-Stop input connection changes it state from closed to open, the welding power source goes into an E-Stop
mode where all welding outputs shutdown immediately. Once the input connection returns to a closed state, the unit
will start a reset routine and be ready for opeation when it completes the reset operation.
B. DeviceNet Option
The DeviceNet option provides hardware and software that allows the welding power source to be connected into a
DeviceNet network.
Contact factory for option details.
C. RMD Option
RMD (Regulated Metal Deposition) is a precisely controlled short-circuit transfer welding process. Some of the bene-
fits provided by the RMD process are the ability to weld thin gauge material and use larger diameter welding wire on
thin gauge material, improved gap filling, reduction of spatter, less heat input into the workpiece, and less distortion.
The RMD process is a software option that is loaded into the welding power source.
Contact factory for option details.
SECTION 5 − OPERATION
2
Pilot Light
Light indicates status of welding power
source, on when unit is on and off when unit is
off.
3
4
3
PDA Port
4
PC Port
OM-216 967 Page 25
Ref. 803 669-A