Miller BOBCAT 225G PLUS Owner's Manual - Page 18

Browse online or download pdf Owner's Manual for Welding System Miller BOBCAT 225G PLUS. Miller BOBCAT 225G PLUS 40 pages.

Print Page

5-2. Optional Auxiliary Power Receptacles

OM-403 Page 14

Y If unit does not have GFCI re-

Combined output of all receptacles

limited to 8 kVA/kW rating of the

generator.

GFCI Receptacle Option

GFCI2 and GFCI3 supply 60 Hz

single-phase power at weld/power

speed. Maximum output from

GFCI2 or GFCI3 is 2.4 kVA/kW.

Circuit breaker protection is the

same as standard receptacles.

If a ground fault is detected, the

GFCI Reset button pops out and

the circuit opens to disconnect the

faulty

damaged tools, cords, plugs, etc.

connected to the receptacle. Press

button to reset receptacle and

resume operation.

South African And Australian

Receptacle Options

Receptacles supply 60 Hz single-

phase power at weld/power speed.

Maximum output from each recep-

tacle is 3.6 kVA/kW.

CB1, CB2, and CB3 protect RC1,

RC2, and RC3 from overload. If a

circuit breaker opens, the recep-

tacle does not work. Press button to

reset breaker.

CB4 protects all the receptacles

from overload. If CB4 opens, none

of the receptacles work.

Ref. ST-178 079-A / Ref. ST-172 782-A / Ref. ST-172 113

ceptacles,

use

GFCI-

protected extension cord.

Auxiliary power decreases as

weld current increases.

Set Fine Adjust control R1 at 10

for full auxiliary power.

120 V 15 A AC GFCI Recep-

tacles GFCI2 And GFCI3

equipment.

Check

for

At least once a month, run

engine at weld/power speed

and press Test button to verify

GFCI is working properly.

240 V 16 A AC South African

Receptacles RC1, RC2, And

RC3

240 V 15 A AC Australian Re-

ceptacles RC1, RC2, And

RC3

Circuit Breakers CB1, CB2,

CB3

Circuit Breaker CB4