Miller Coolmate 1.3 Owner's Manual - Page 13
Browse online or download pdf Owner's Manual for Welding System Miller Coolmate 1.3. Miller Coolmate 1.3 20 pages. Recirculating coolant system for water-cooled gtaw torches and gmaw guns
Also for Miller Coolmate 1.3: Owner's Manual (28 pages)
Print Page
5-1. GTAW Connections
!
Do not move or operate unit where
it could tip.
To prevent overheating, make sure cooling
unit is positioned so there is 12 in. (305
mm) of unrestricted airflow on sides of unit.
NOTICE − If welding power source has a
water valve, do not connect hoses to water
valve. Connect hoses as shown.
1
Coolant Out Hose
2
Coolant In Hose
.
A complete Parts List is available at www.MillerWelds.com
SECTION 5 − INSTALLATION
Fittings have 5/8-18 left-hand threads.
Connect hoses with proper fittings as
shown. Some power sources may require
a TIG block.
3
Coolant Tank Cap
4
115 Volt AC Grounded Receptacle
A dedicated circuit capable of carrying 15
amperes and protected by fuses or circuit
breakers
is
recommended.
mended fuse or circuit breaker size is 15
amperes.
3
1
2
Operation:
Fill tank with proper coolant. Use table in
Section 4-3 to select proper coolant. Main-
tain coolant level at approximately 1 in. (25
mm) below top of filler neck. Connect
hoses as shown. Unit turns on when
plugged in.
.
For correct water cooled torch ad-
Recom-
apters, see the Coolmate Series Op-
tions And Accessories page.
4
Tools Needed:
11/16 in.
805 500-A
OM-257811 Page 9