ABB DODGE COOL LUBE 2 Instructions - Page 4

Browse online or download pdf Instructions for Industrial Equipment ABB DODGE COOL LUBE 2. ABB DODGE COOL LUBE 2 4 pages.

Print Page

Hydraforce RV08-20H-0-N5/.75

Maintenance:

Periodically check the oil level in the bearing housings and the

Cool Lube 2 to ensure proper operation.

Most foreign material in a system ﬂushes to the reservoir after

the first few hours of operation. We recommend that you drain

the tank, replace the ﬂuid, change the filter, and clean the

suction strainer after 3-5 hours of operation. After the initial

cleaning, the strainer should be cleaned at a minimum of every

4000 hours of operation. More frequent cleaning is required if

the system is used in a highly contaminated atmosphere such

as a foundry or paper mill.

—

ABB Motors and Mechanical Inc.

5711 R. S. Boreham Jr. Street

Fort Smith, AR 72901

Ph: 1.479.646.4711

Mechanical Power Transmission Support

Ph: 1.864.297.4800

new.abb.com/mechanical-power-transmission

baldor.com

MN3083

Figure 3 - Relief Valves

After the initial replacement, the supply line filter should be

replaced periodically as required by operating conditions.

Check the visual clog indicator on the filter head between filter

changes to ensure the filter is not being bypassed.

Good preventative maintenance is the best insurance against

unscheduled downtime. Unscheduled downtime is usually more

expensive than preventive maintenance.

NOTE: Cool Lube 2 units manufactured after September

2016 utilize a new relief valve for the pressure line only.

Previous Relieve Valve: Hydraforce RV08-20H-0-N-5/.75

New Relief Valve: Fulflo VJ-3R/HS/WS

For Cut Sheets of each valve, contact manufacturers.

Fulflo VJ-3R/HS/WS

*3083-0818*

08/18