aquanta AQ-CA-E300-1 Installation Instructions Manual - Page 8
Browse online or download pdf Installation Instructions Manual for Controller aquanta AQ-CA-E300-1. aquanta AQ-CA-E300-1 12 pages. Smart water heater controller
Print Page
through the slot. Position the Temperature Sensor on the cold water pipe as close
as possible to the water heater and under the Cable Tie then pull the Cable
Tie as tight as possible. Place a second Cable Tie around the Temperature Sensor
wire and water pipe as a strain relief. Clip off the excess length of the Cable Ties. Plug
this Temperature Sensor into the "Cold" connector (the middle 2-pin port) on the
side of Aquanta (see Step 4 below).
3. OPTIONAL: If you purchased the Leak Sensor, peel the
paper backing off of the double-sided tape on the Leak
Sensor. Place the Leak Sensor on the side of the water
heater near bottom, preferably directly below the T&P
valve, such that the gold-plated contacts extend into the
drip pan beneath the water heater. Plug the Leak Sensor
into the "Leak" connector on the side of Aquanta (see
Step 4 below).
4.
Connect the sensors to Aquanta as marked. The "AUX" port is not used.
The T&P sensor goes on the Temperature & Pressure relief valve.
8