Miller Syncrowave 351 Owner's Manual - Page 26

Browse online or download pdf Owner's Manual for Welding System Miller Syncrowave 351. Miller Syncrowave 351 42 pages. Arc welding power source

Print Page

5-3. Adjusting Spark Gaps

4
3
2
Tools Needed:
0.008 in (0.203 mm)
OM-354 Page 22
1
5/32 in
Y Turn
Off
power
before
adjusting spark gaps.
Open access door.
1
Tungsten End Of Point
Replace point if tungsten end dis-
appears; do not clean or dress
tungsten.
2
Spark Gap
Normal spark gap is 0.008 in (0.203
mm).
If adjustment is needed, proceed as
follows:
3
Adjustment Screws
Loosen screws. Place gauge of
proper thickness in spark gap.
4
Pressure Point
Apply slight pressure at point until
gauge is held firmly in gap. Tighten
screws. Adjust other gap.
Close access door.
Ref. ST-149 842-E / Ref. S-0043