Miller XMT 425 CC/CV Owner's Manual - Page 13

Browse online or download pdf Owner's Manual for Welding System Miller XMT 425 CC/CV. Miller XMT 425 CC/CV 40 pages.

B. Information On Electromagnetic Fields (EMF)

This equipment shall not be used by the general public as the EMF limits for the general public might be exceeded during welding.

This equipment is built in accordance with EN 60974−1 and is intended to be used only in an occupational environment (where the general public

access is prohibited or regulated in such a way as to be similar to occupational use) by an expert or an instructed person.

Wire feeders and ancillary equipment (such as torches, liquid cooling systems and arc striking and stabilizing devices) as part of the welding

circuit may not be a major contributor to the EMF. See the Owner's Manuals for all components of the welding circuit for additional EMF exposure

information.

The EMF assessment on this equipment was conducted at 0.5 meter.

At a distance of 1 meter the EMF exposure values were less than 20% of the permissible values.

C. Information On Electromagnetic Compatibility (EMC)

This Class A equipment is not intended for use in residential locations where the electrical power is provided by the public low−

voltage supply system. There can be potential difficulties in ensuring electromagnetic compatibility in those locations, due to con-

ducted as well as radiated disturbances.

This equipment complies with IEC61000-3-11 and IEC 61000−3−12 and can be connected to public low-voltage systems provided that the public

low-voltage system impedance Z

2,055,437.437 VA). It is the responsibility of the installer or user of the equipment to ensure, by consultation with the distribution network operator

if necessary, that the system impedance complies with the impedance restrictions.

Notes

at the point of common coupling is less than 77.84 mW (or the short−circuit power S

max

ce-emf 1 2010-10

is greater than

ce-emc 1 2014-07

OM-257 486 Page 9