Miller XR-ALUMAFEED Owner's Manual - Page 22

Browse online or download pdf Owner's Manual for Welding System Miller XR-ALUMAFEED. Miller XR-ALUMAFEED 44 pages.

Print Page
Miller XR-ALUMAFEED Owner's Manual

5-6. 14-Pin Plug Information

J
A
K
I
B
L
H
N
C
M
G
D
F
E
*The remaining pins are not used.

5-7. Installing Wire Spool

3
OM-239 210 Page 18
Pin*
A
24 volts AC with respect to socket G.
B
Contact closure to A completes 24 volts AC contactor control circuit.
G
Circuit common for 24 volts AC circuit.
C
+10 volts DC input from power source to wire feeder with respect to socket D.
D
Remote control circuit common.
E
0 to +10 volts DC output signal from wire feeder to power source with respect to socket D.
H
Voltage feedback; 0 to +10 volts DC, 1 volt per 10 arc volts.
F
Current feedback; 0 to +10 volts DC, 1 volt per 100 amperes.
L
0 to +10 volts DC output signal from wire feeder to power source with respect to socket N.
N
Feeder common.
M
0 to +10 volts DC output signal from wire feeder to power source with respect to socket N.
3
2
4
1
Pin Information
5
1
Wire Spool
2
Hub
3
Hub Pin
4
Notch
5
Retaining Ring
Slide spool onto hub so wire feeds
off bottom. Turn spool until hub pin
fits hole in back of spool (notch on
hub aligns with hub pin for guid-
ance). Reinstall retaining ring.
Thread welding wire
(see Section 5-8).
Tools Needed:
Ref. 805 350-A / 072 573-B