Miller XR-S Control Owner's Manual - Page 19

Browse online or download pdf Owner's Manual for Welding System Miller XR-S Control. Miller XR-S Control 40 pages. Wire feeder and feeder gun

Print Page

5-2. Air-Cooled Feeder Connections

Connect To 14-Socket
Receptacle On Welding
Power Source
1
Connect To Positive (+)
Weld Output Terminal On
Welding Power Source
Tools Needed:
9/16 in.
2
4
Rear Panel
3
1
Connect one end of 10 ft (3 m) gas
hose to rear of unit, gas solenoid fit-
ting. Connect remaining end of
hose to regulator/flowmeter.
.
2
Select and prepare weld cable
according to welding power source
manual.
3
4
5
Route one end of weld cable
through grommet, through reed
relay, and connect to weld cable ter-
minal in feeder. Connect remaining
end of cable to positive (+) weld
output terminal on welding power
source.
5
5
2
Top View
Gas Fitting
Shielding gas pressure not to
exceed 100 psi (689 kPa).
Weld Cable To Welding Power
Source
Weld Cable Grommet
Current Sensing (Reed) Relay
Weld Cable Terminal In
Feeder
Ref. 246 218-C
OM-245777 Page 15