Miller XT30C Manual - Page 15
Browse online or download pdf Manual for Welding System Miller XT30C. Miller XT30C 40 pages.
Also for Miller XT30C: Owner's Manual (40 pages)
Print Page
3-3. XT30C Specifications
Torch −
The XT30C torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum 375.
Do not use this torch in combination with any other machines.
Gas Type
Gas Quality
Gas Inlet Flow and Pressure
Gas Filtering
Cooling Method
Duty Cycle of Torch
Rating of Electrical Controls (Trigger)
Rating of Electrical Controls (Cup)
Approved Systems
Trigger Protection
Safety Devices
Rated Capacity (edge start)
Sever Cut Capacity (edge start)
Pierce Capacity
*Travel speeds are approximately 80% of maximum.
Weight
Requirements for the torch connection
S
Use only compressed air which is free from dirt, oil, and water.
S
Ensure that the connections are properly assigned and tightened.
S
For torch replacement, see Miller torch manual Part No. OM-1593
Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.
S
3-4. XT30C Torch Dimensions
1-3/16 in.
(30 mm)
Air or Nitrogen
Clean, moisture−free,
oil−free
5.0 SCFM (142 L/min)
Particulates to 5 microns
Air
100% at 30 Amps
30 VDC at .1 Amps
30 VDC at 1 Amp
Spectrum 375 X-TREME w/XT30
torch
Safety trigger guard
Safety interlock devices shut
down power source
3/8 in. at 15 ipm (381 mm/min)*
5/8 in.
3/16 in.
3.2 lb (1.5 kg)
8-3/4 in.
(222 mm)
1-1/2 in.
(38 mm)
−−
−−
−−
−−
90 PSI (621 kPa)
120 PSI (827 kPa)
Min
Max
−−
−−
−−
−−
−−
−−
− −
− −
− −
− −
−−
−−
−−
−−
−−
−−
− −
− −
Ref. 253 554-A
OM-254 449 Page 11