Miller Infinity Series Owner's Manual - Page 24

Browse online or download pdf Owner's Manual for Welding Accessories Miller Infinity Series. Miller Infinity Series 32 pages. Auto-darkening helmets
Also for Miller Infinity Series: Owner's Manual (32 pages)

Print Page

SECTION 7 – REPLACING LENS COVERS

7-1.

Replacing The Lens Covers

Never use the auto-darkening lens

without the inside and outside lens

covers properly installed. Welding

spatter will damage the auto-darken-

ing lens and void the warranty.

Outside Lens Cover

1 Lens Holder

2 Lens Holder Release Points

3 Outside Lens Cover

Remove lens holder by pulling the holder

away from the helmet in either bottom

corner.

Remove lens cover from shell by pulling top

center of lens. Replace lens cover in lens

holder by placing one edge in place, bending

lens cover, and inserting opposite edge into

lens holder channel. Reinstall lens holder in

helmet.

Inside Lens Cover

4 Auto-Darkening Lens

OM-289711 Page 22

5 Inside Lens Cover

Remove the inside lens cover by pulling top

center of lens cover from lens holding

channels.

Replace the lens cover by gently bowing it in

the center and inserting it, one end at a time,

into the lens holding channels.

�

Auto-Darkening Lens

6 Lens Release Tabs

Remove lens holder and outside lens cover

using instructions above. Press down on

both lens release tabs and push auto-dark-

ening lens assembly from the inside to

remove.

Replace the lens by aligning it on the re-

lease tabs and pressing it in until it snaps in-

to place.

804814 / 804816

Be sure the cover lens is seated prop-

erly to prevent fogging.