Miller M-10 Owner's Manual - Page 27
Browse online or download pdf Owner's Manual for Welding Accessories Miller M-10. Miller M-10 48 pages. Air-cooled guns for gmaw and fcaw welding
Also for Miller M-10: Owner's Manual (8 pages)
Print Page
6-5. Replacing Switch And/Or Head Tube
1
Remove handle
locking nut.
4
Secure head
tube in vice.
6
Hand-tighten head tube into cable connector.
Tools Needed:
19 mm
Y Turn Off welding power source
/wire feeder and disconnect gun.
5
Loosen jam nut.
Remove from vice
and turn head tube
out by hand.
8
Remove from vice. Reposition handle and install
switch housing. Secure with handle locking nut.
3
Slide handle.
2
Remove switch housing. Install new switch and
connect leads (polarity is not important). Reas-
semble in reverse order. If replacing head tube,
continue to end of figure.
7
Place head tube in vice and tighten until
nuts are tight.
Ref. ST-800 795-C
OM-1328 Page 23