Miller 1009728 User Instructions - Page 5

Browse online or download pdf User Instructions for Safety Equipment Miller 1009728. Miller 1009728 48 pages. Single anchor point

Print Page

• Leave the QUICKLOCK in place permanently.

• Work suspended on the QUICKLOCK.

THIS PRODUCT MUST BE:

• Used by ONE PERSON ONLY provided with an anti-fall

system in compliance with EN 355, EN 353/2, EN 360.

• Used by trained personnel.

• Used with self-locking connectors in compliance with

the EN 362 standard.

• Withdrawn after a fall.

INSTALLATION

Select a solid concrete support with a minimum resistance of 23 Mpa. Carry out, if necessary, a pulling trial on a test

point in order to verify that the anchor support is adequate (5 kN for 5 seconds).

Using an industrial drill, with an appropriate bit for concrete, drill a hole that is perfectly straight and uniform, of

Ø 18 mm and depth 90 mm.

YOUR SAFETY DEPENDS ON THE QUALITY OF THE DRILLING AND THE CONCRETE

The anchor point must not be less than 155 mm from the edge of the concrete sup-

port, and must not be less than 188mm from another anchor point.

Introduce the QUICKLOCK into the hole.

Half-shell

Guiding

cable

Cable

guide

Blocking

cone

INSTRUCTIONS FOR USE:

Insert the QUICKLOCK ref. 1009728 into the hole by pulling on the trigger (compression of the spring). Before introduc-

ing it, check that the 2 half-shells are perfectly parallel (see figure below). Push the QUICKLOCK into the hole to halfway

along the position indicator. Release the trigger and exert a slight traction. Once the anchor has been introduced, attach

your connector.

The QUICKLOCK must be perfectly positioned. Check that the depth indicator is

introduced halfway into the hole. The cables of the half-shells must be symmetrical (see

photos). Check the blocking hold by exerting a light traction on the QUICKLOCK loop.

• Work without an anti-fall system if there is a risk of falling.

• Use the QUICKLOCK on a support other than concrete.

• Taken away after utilisation.

• Fixed in a perfectly straight hole of the correct diameter.

• The drilling must be carried out with an industrial drill.

• Used only if the identification label is still in place on the

equipment.

Safety

cable

Spring

Safety

trigger

Position

indicator

Polyurethane

Fastening

sheath

Anti fall

fixation loop

DEPTH

INDICATOR