3B SCIENTIFIC 1009934 Instruction Manual - Page 3
Browse online or download pdf Instruction Manual for Science Education products 3B SCIENTIFIC 1009934. 3B SCIENTIFIC 1009934 5 pages. Basic hall effect apparatus
Print Page5. Technical data
Power supply:
max. 12 V AC, 3 A via 4-mm safety sockets
Constant current source for sample current:
Current:
Display precision:
Display resolution:
Measurement output:
Hall voltage and compensation:
Display:
Display precision:
Display resolution:
Compensation:
Measurement output:
Sample voltage:
Display:
Display precision:
Display resolution:
Measurement output:
Sample temperature:
Range:
Display precision:
Display resolution:
Measurement output:
Attachment for circuit boards:
Connector:
Outputs:
Hall voltage:
Voltage drop across
germanium crystal:
Voltage equivalents:
General data:
Dimensions:
Weight:
6. Operation
6.1 Experiment set-up for uniform magnetic
field and attachment of circuit boards
The following equipment is necessary to set up a
uniform magnetic field:
1 P-Doped Germanium on Circuit Board 1009810
or
1 N-Doped Germanium on Circuit Board 1009760
or
1 Undoped Germanium on Circuit Board 1008522
1 U Core D
1 Pair of Pole Shoes and Clamping Brackets D
for Hall Effect
2 Coils D with 600 Turns
1 Magnetic field sensor FW ± 2000 mT 1021766
0 to ±34 mA, tol.: ±1 mA
±2.5 %
0.1 mA
I
= Umeas * 0.1 A/V
P
0 to ±199.9 mV
±2.5%
0.1 mV
±10 mV, tol.: +5 mV
U
= Umeas * 0.1
H
0 to ±1.999 V
±2.5%
1 mV
U
= Umeas
P
T
to 170°C, tol.: ±3°C
0
±2%
0.1 °C
T (°C) = Umeas * 100/V
Multi-pin socket
4-mm safety sockets
4-mm safety sockets
4-mm safety sockets
8-pin mini-DIN sockets
180x110x50 mm approx.
0.5 kg approx.
1000979
1009935
1000988
Fig. 4: Set-up on U-shaped core with coils, pole
pieces and U-shaped holder
Place the U-shaped core on a stable, level
surface.
Place coils over the core in such a way that
their connectors are facing the front.
Insert the U-shaped holder all the way into
the hole in the U-shaped core and secure it in
place with the knurled screw.
Place the pole pieces on the legs of the core
and secure them in place with clamps (see
Fig. 4).
Insert the circuit board into the attachment on
the console until the contact pins slot into the
multi-pin socket. Make sure the circuit board
is correctly aligned (see Fig. 5).
Insert the console with the circuit board at-
tached onto the U-shaped holder. Make sure
the board is held parallel with the U-shaped
core. You may need to turn the U-shaped
holder slightly (see Fig. 6).
Insert the magnetic field sensor into the cor-
responding attachment on the console.
Undo the clamps and move the pole pieces
as far as the spacers on the circuit board
(make sure the board does not get warped)
(see Fig. 7/8).
Fig. 5: Insertion of circuit board
3