AQUAPHOR RO-312S PRO Operation Manual - Page 10

Browse online or download pdf Operation Manual for Water Filtration Systems AQUAPHOR RO-312S PRO. AQUAPHOR RO-312S PRO 17 pages. Reverse osmosis system

Print Page

Cutter Operation

• Install the cut-off device as far as it will go into

the neck or on the wall of the container (for

example, bottles or pans).

• Ensure that the cutter is securely secured with

a latch.

• Insert the tip into the cutter hole.

• Wait for the container to fill with clean water,

disconnect the tip from it, and turn off the wa-

ter supply.

• Disconnect the isolator from the container.

• If it is necessary to stop the collection of water

into the tank ahead of schedule, just press the

button located on the end of the cutter.

Changing the replacement cartridge

The service life of the membrane cartridge (3)

directly depends on the performance of the water

treatment unit (2). Therefore, it is very important

to timely replace the filter cartridges.

Replacing K1 and K7M Cartridges

• Close the inlet valve on the connection unit

and connect the tip to the storage tank to re-

lieve pressure.

• Turn the used cartridge counterclockwise and

remove it.

• Remove the packing tape from the new

cartridge.

• Insert the new cartridge into the manifold block

until it stops and, while slightly pressing, turn

the cartridge clockwise until it clicks.

• Install the flushing plug in the middle slot (in-

stead of the membrane cartridge).

• Open the input tap on the connection node.

• Insert the tip into the slot of the cutter, holding

it above the sink.

• Holding the tip, place the cutter in the sink, then

drain the water passing through the RO-312S

Pro within 10 minutes.

• Disconnect the tip from the cutter by pressing

the key located on the end of the cutter.

• Close the inlet tap.

* Depending on the conditions of storage, transportation and operation, the time for complete washing of the membrane cartridge

may vary, but takes no more than 24 hours.

Clean Water Tip

Clipper slot

Shutdown key

Latch

• Remove the flushing plug and install the mem-

brane cartridge by turning the cartridge clock-

wise until it clicks.

• Open the inlet crane and make sure that the

RO-312S Pro connections are tight.

Replacing a RO-100S Cartridge

• Close the inlet tap and connect the tip to the

storage tank to relieve pressure.

• Turn the used membrane cartridge counter-

clockwise and remove it.