Aquaport AQP-FKW Manual - Page 8
Browse online or download pdf Manual for Water Filtration Systems Aquaport AQP-FKW. Aquaport AQP-FKW 16 pages. Full flow water filtration system
Print Page
3. Tubing Installation
The Filtration System has been supplied with quick and easy to
install quick connections.
a) Measure a length of 3/8" tubing (3) to run from the
Female 1/2" thread to 3/8" push in fitting (5) to the
filter head inlet (2c) and another length of tubing to run
from the filter head outlet (2d) to the end of the cold
water flexible hose connected to the tap.
b) Install the tubing as per the installation diagram on
page 3. To install tubing, push tubing into connections
and give a slight pull to ensure tubing is secure.
Note: check the end of the tubing to make sure there are no
cuts, nicks, flat spots or sharp edges. If any of these are present,
re-cut the end with a tube cutter or utility knife. The cut must
be perfectly straight with no angle, otherwise leaking from the
connections may occur.
Note: To remove tubing, push collet against the face of fitting
and remove the hose (with collet still held against fitting face).
Fig 3.
6 INSTALLATION AND OPERATING INSTRUCTIONS
4. System Start Up
a) Turn cold tap to 'ON' position. Turn water supply 'ON'
slowly at isolation tap or water meter. Note- air may be
purged from the filter system at this time.
b) Check for any leaks and fix if necessary. If leaks are
present connections may need to be reinstalled.
c) Leave tap on to allow water to flush through the
system for approximately 5 minutes. You may wish to
collect the water for use in the garden.
Note: Tiny air bubbles being expelled from the cartridge will
cause the water supply to appear "cloudy", this is normal.
This condition will clear itself over use, or you may flush water
through the system until water appears clear.
d) Your Aquaport water filtration system is now ready to
produce refreshing, great tasting water for you and
your family.
Fig 3
Push
Push Collet
Collet
Pull
Pull Tubing
Tubing