AquaPRO 62041 Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Water Pump AquaPRO 62041. AquaPRO 62041 11 pages. Automatic booster pump

Print Page

TROUBLESHOOTING

Problem

Possible Cause

Motor will not run.

1. Fuse is blown or circuit breaker tripped.

2. Power cord not plugged in.

Motor runs hot

1. Voltage is too low.

and overload

kicks off or motor

2. Impeller not moving freely

does not run and

only hums

Motor runs but no

1. Improper priming.

water is

2. Clogged water filter.

delivered.* *

3. Discharge valve closed

Unplug pump,

4. Pipe size too small

then open faucets

5. Impeller is plugged

and see if water is

6. Pipes are frozen

flowing through

system

Pump does not

1. Corroded pipes.

deliver water to

2. Piping is too small in size.

full capacity.

3. Pump not being supplied with enough water.

4. Low voltage

Corrective Action

1. DISCONNECT POWER; Replace fuse or

reset circuit breaker.

2. Plug into 115 Volt grounded outlet.

1. Check voltage being supplied to pump.

2. Check that impeller moves freely and is not

clogged.

1. Re-prime according to instructions.

2. Stop pump, shut off water, and change filter

cartridge. Filter should be installed on

discharge side of pump.

3. Open valve.

4. Re-pipe using pipe of the same size as

suction and discharge ports on pump.

5. Clean impeller.

6. Thaw pipes.

1. Replace with plastic or new steel pipe.

2. Re-pipe using pipe the same size as suction

and discharge ports on pump

3. Enlarge inlet pipe; check well pump system.

4. Make sure outlet voltage is at 115 Volts.