Burley 9307 Fireball Installation Instructions & User Manual - Page 16
Browse online or download pdf Installation Instructions & User Manual for Wood stove Burley 9307 Fireball. Burley 9307 Fireball 20 pages.
![Burley 9307 Fireball Installation Instructions & User Manual](/uploads/products/server2/363359/363359.jpg)
Troubleshooting/Poor Appliance Operation
Refuelling onto a low
fire bed
Air damper left fully
open
Leaving door open
Overloading the fire
bed
Substantial Smoke
Emission
Door Adjustment
Page 16 of 20
If there is insufficient burning material in the firebed to light a new
fuel charge, excessive smoke emission can occur. Refuelling
must be carried out onto a sufficient quantity of glowing embers
and ash that the new fuel charge will ignite in a reasonable
period. If there are too few embers in the fire bed, add suitable
kindling to prevent excessive smoke
Operation with the air controls or appliance dampers open can
cause excess smoke. The appliance must not be operated with
air controls, appliance dampers or door left open except as
directed in the instructions. Although the fire will look impressive,
you will be burning more wood for less heat. The glass can also
be damaged.
Operation with the door open can cause excess smoke and be a
potential fire hazard. The appliance must not be operated with
the appliance door left open except as directed in the
instructions.
The maximum amount of fuel specified in this manual should not
be exceeded.
The weight of dry wood per hour is: 1.75kg for the 9307.
Overloading can damage components of the stove. The stove is
not designed for overnight operation.
If substantial smoke emission is observed from the appliance at
any time during the operation of the appliance the operator
should ensure they are following the operation instructions and
using suitable fuel. The flue may not be pulling as it is too cold or
incorrectly specified/installed. There might be a down draught.
Check that the top brick is at the back of the fire.
The locking mechanism on the door is made up of a cam and
lobe assembly. The door can be loosened or tightened with an
Allen key (see page 11). The door will need to be adjusted over
time as the rope seal compresses.