Panasonic AGDVC20P - 3 CCD DV CAMCORDER Operating Instructions Manual - Page 16
Browse online or download pdf Operating Instructions Manual for Camcorder Panasonic AGDVC20P - 3 CCD DV CAMCORDER. Panasonic AGDVC20P - 3 CCD DV CAMCORDER 40 pages. Agmini-dv camera/recorder
Also for Panasonic AGDVC20P - 3 CCD DV CAMCORDER: Operating Instructions Manual (42 pages), Operating Instructions Manual (42 pages)
Print Page
DVC20_Eng.book 16 ページ ２００５年１０月３１日 月曜日 午前１０時３６分
ª
Selecting the remote control mode
If 2 cameras are used simultaneously, set the mode for one pair
of camera-recorder and remote control to [VCR1] and that of
the other pair to [VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When the button-
type battery is replaced, the setting will revert to the default
[VCR1].)
1
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].
2
Setting on the remote control:
STILL ADV
PAUSE STILL ADV
2
STOP
VAR
[VCR1]:
Press [D] and [∫] simultaneously. 1
[VCR2]:
Press [E] and [∫] simultaneously. 2
ª
Concerning the button-type battery
≥When the button-type battery runs down, replace it with a new
battery (part number: CR2025). The battery is normally
expected to last about 1 year, but it depends on operation
frequency.
≥Keep the button-type battery out of the reach of children.
≥If the remote control mode of the camera and that of the
remote control do not match with each other, "REMOTE" will
appear. When the remote control is operated for the first time
after the camera is turned on, "CHECK REMOTE MODE"
(
) will appear and operation is impossible. Set the same
-32-
remote control mode.
≥The remote control is intended for indoor operation. Outdoors
or under strong light, the camera-recorder may not operate
properly even within the usable ranges.
≥Within a 1 m (3 feet) range, you can operate the remote
control from beside the remote control sensor (LCD monitor
side) of the camera-recorder.
16
Before using
VOL
1